Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Gate Motor & Opener Service for Boulder City Homeowners
A gate that won’t open is a driveway you can’t use, and in Boulder City that usually shows up at the worst possible moment – a motor that hums but doesn’t move, an arm that stalls halfway, or a remote that quit without warning. We repair, replace, and install gate motors and openers for homeowners here, and our technicians have up to 13 years of experience with the automation that runs driveway and estate gates. Most motor repairs are finished in a single visit, and we answer a live person on the phone 24 hours a day. Call (888) 276-7609 and we’ll get your gate moving again, with the price settled before any work starts.

What Our Gate Motor & Opener Service Includes
Gate automation isn’t one part. It’s a motor, an arm or track, a control board, safety sensors, and a power supply working together. When something fails, the trick is finding the actual cause rather than replacing the whole operator. Here’s what we handle in Boulder City.
Motor Installation
A new motor installation means matching the operator to your gate before anything is ordered. We weigh the gate, check the hinge condition, look at the swing or slide path, and confirm the power run before we recommend a unit. If a gate is heavy or sagging, the right motor on a bad hinge will fail early, so we fix the gate first. We install and set up operators on swing and slide gates, set the limits and force, and walk you through the controls before we leave. New motor work is measured and scheduled, not rushed, so you get a written price before we order a thing.

Motor Repair
Most motor calls come down to a handful of causes: a control board that’s failed, a limit switch out of adjustment, a capacitor gone weak, or an arm that’s bound up on a worn hinge. We diagnose the actual fault with a meter and a careful test of the gate’s travel, then quote the repair before we touch it. When a unit is genuinely at the end of its life, we’ll tell you that plainly instead of charging for a fix that won’t hold. Repairs are the bulk of what we do, and most are done the same day you call.

Linear Motor
Linear operators are common on residential swing gates, and they’re reliable until the arm bushings wear or the control board loses its programming. We service Linear equipment and know where it wears out, which saves you the cost of guessing. If your Linear unit is stalling, reversing on its own, or ignoring the remote, we can usually trace it to one component rather than the whole operator. Call for an exact quote on a Linear repair, and we’ll tell you whether it’s a fix or a replacement.

Slide Motor
Sliding gates put different demands on a motor than swing gates do. The track has to be clear, the rollers have to roll true, and the operator has to be sized for the weight of the gate, or it will strain and fail. We check the track, the guide rollers, and the rack before we touch the motor, because a bound slide gate will burn out a good operator. When the motor is the problem, we repair or replace it and reset the travel so the gate stops where it should. Slide motor work is scheduled after a look at the gate itself, and the price is agreed upfront.
Intercom Integration
An intercom lets you see and speak to whoever is at the gate before you let them in, and it has to be wired and programmed alongside the operator to work properly. We integrate intercoms with your gate controls so one button handles the conversation and the entry, and we test the whole chain before we call it done. If your existing intercom has gone silent or the gate no longer responds to it, we can trace the fault through the wiring and the control board. This is scheduled work, measured and quoted in advance.
Battery Backup
Battery backup keeps your gate working through a power outage, which matters more than people expect when the gate is the only way in or out. We install and replace backup batteries, test them under load, and check that the charging circuit is actually keeping them topped up. A backup that’s never been tested is a backup you can’t count on, so we verify it works before we leave. If your gate died during the last outage, call us and we’ll check the battery and the charging side together.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Brands We Service for Gate Motor & Opener
We’re trained and equipped on nine gate-automation brands, so whatever is on your driveway, the right fix gets made on the first visit. LiftMaster operators are common on residential driveways, and we know their control boards and limit settings well enough to diagnose a fault quickly. DoorKing equipment shows up on gates that need tighter access control, and we’re comfortable working through its programming and wiring. Linear and Elite units round out a lot of what we see in Boulder City, and each has its own wear points we’ve learned to check first.
Mighty Mule operators are popular with homeowners who installed their own gate, and we can pick up where a DIY job left off without judgment. We also service FAAC, BFT, Viking, and Ghost Controls units. We don’t claim to stock every part for every brand, but we know where each one fails and how to get it running again. Whether you have LiftMaster, DoorKing, Elite, or any other make, we can help.
Signs You Need Gate Motor & Opener Service Right Now
- The motor hums but the gate doesn’t move. That’s usually a bound gate, a failed capacitor, or a stripped gear, and running it longer can burn out the motor. Stop cycling it and have it looked at.
- The gate reverses or stops halfway. A limit switch out of adjustment or a failing safety sensor will cause this, and it’s a sign the operator is confused about where the gate is. It’s often a quick fix if caught early.
- The remote only works up close, or not at all. Weak batteries, a bad receiver, or antenna damage can all cause it. We trace the signal rather than guessing at parts.
- The gate is slow, jerky, or loud. Grinding or straining means the operator is working harder than it should, usually because of worn hinges or a dry track. Left alone, it shortens the motor’s life.
- The gate quit during a power outage and didn’t come back. That points to a dead backup battery or a charging circuit that’s failed. A backup that’s never been tested isn’t a backup.
Our Gate Motor & Opener Process – Step by Step
- 1
We answer the phone. A live person picks up 24 hours a day, so you’re not leaving a message and waiting until Monday. We ask what the gate is doing and set a time that works for you.
- 2
We diagnose before we quote. On arrival we test the operator, the controls, and the gate’s travel with a meter, then check the hinges and track. Finding the real fault first is what keeps you from paying for parts you didn’t need.
- 3
You get a written price upfront. We explain what’s wrong in plain terms and give you a firm price before any work begins. No surprises on the bill, and no work started until you agree.
- 4
We do the work and test it. Repairs are usually finished in a single visit. We cycle the gate, set the limits and force, and confirm the safety sensors and backup are working before we pack up.
- 5
We back it in writing. Every job carries our 90-Day Done Right Promise. If it isn’t right, we come back and make it right, no arguing and no paperwork chase.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Motor & Opener Service Cost in Boulder City?
Prices depend on the operator, the gate, and whether the fault is electrical or mechanical. Here’s a rough picture of what homeowners here typically see:

| Service | Typical Range |
|---|---|
| Diagnostic visit and repair quote | $75 – $150 (often credited toward the repair) |
| Motor repair (board, limit switch, capacitor) | $180 – $450 |
| Battery backup replacement | $150 – $350 |
| New swing or slide motor installation | $900 – $2,400, depending on gate weight and power run |
| Intercom integration | $250 – $700 |
What moves the price is gate weight, the condition of the hinges and track, whether a power run is needed, and the brand of operator. You avoid overpaying by getting the fault diagnosed properly rather than replacing parts one at a time. Every free estimate includes a full inspection of the gate and operator, a written price, and a plain explanation of what we found. We also have standing offers that help: $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a 5% senior and veteran discount, always.
Gate Motor & Opener Near Boulder City – Our Service Area
We serve homeowners across Boulder City and the surrounding communities, including Henderson, Winchester, and Whitney. Response times depend on the day, but we work to get to you quickly and keep you informed. Wherever you are in the area, call and we’ll give you an honest window. Back to our home page for the full scope of what we do.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Gate Motor & Opener in Boulder City
A gate motor and opener is the automated system that opens and closes your driveway or estate gate without you getting out of the car, using an operator, a control board, and a remote or keypad. It’s the machinery behind the gate, not the gate itself, and it has to be matched to the gate’s weight and travel. When any part of the system fails, the gate stops responding even if the gate itself is fine. We repair and install these systems, and we’ll tell you exactly which part is causing trouble.
Most motor repairs take one to three hours and are finished in a single visit. Simple fixes like a limit switch or a capacitor are quick; a control board replacement takes a little longer because we program and test it afterward. New installations are measured and scheduled, so the timing depends on ordering the right operator for your gate. Call (888) 276-7609 and we’ll give you a realistic time for your specific gate.
Most gate motor repairs here run $180 to $450, depending on whether the fault is a board, a limit switch, or a capacitor, and on the brand of operator. The price is quoted and agreed before any work starts, so you never get an invoice bigger than the quote. We also take $50 off any repair over $250. Call (888) 276-7609 for an exact quote, and estimates are free.
Yes, we service LiftMaster operators along with DoorKing, Elite, Linear, FAAC, BFT, Viking, Ghost Controls, and Mighty Mule. We’re trained on nine gate-automation brands, so the right fix gets made on the first visit. If your LiftMaster unit is stalling or ignoring the remote, we can trace it to the actual component. Call and tell us what it’s doing.
Often, yes. Motor repair and emergency calls are the work we can usually get to the same day, and a live person answers the phone 24 hours a day, so you’re not waiting on a callback. If your gate is stuck open or shut, call right away and we’ll tell you the soonest we can be there. New installations and intercom work are scheduled after a measure and a written quote, not rushed.
Every completed job is covered by our 90-Day Done Right Promise, a written guarantee with no hassle and no arguing. If something we worked on isn’t right, we come back and make it right. It’s the same standard on a small repair as on a full motor installation. That’s the Keystone Standard, and it’s applied to every gate job.
Clear the area around the gate so we can walk the full travel, and have your remote and any gate codes handy so we can test the controls. If you have the operator manual or know the brand, that helps us bring the right parts. Tell us what the gate does and doesn’t do when you call, and we’ll arrive ready. Then we diagnose, quote, and get to work once you agree.
Schedule Your Gate Motor & Opener Service in Boulder City Today
If your gate won’t open, won’t close, or just isn’t acting right, don’t wait for it to fail completely. Call Ironworks Gate Co. at (888) 276-7609 for a free, no-obligation estimate in Boulder City. A live person answers 24 hours a day. We’ll diagnose the fault, quote a firm price before any work starts, and back the job with our 90-Day Done Right Promise. Done right, and backed in writing.
Written by the team at Ironworks Gate Co.