Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Repair Before & After in Boulder City, NV
Pictures of finished work tell you more than any sales pitch we could write. Below are the kinds of gate problems we solve around Boulder City – gates that stopped latching, operators that quit, rusted hinges that screamed, keypads that ignored everyone. Every job here was priced upfront, done in one visit where possible, and backed in writing by our 90-Day Done Right Promise. The photos are placeholders for now, ready for the real finished work.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Recent Transformations
Gate Repair: Sagging Double-Drive Gate That Dragged on the Pavement
Before
After
Before
AfterThe problem: heat and settling had pulled the gate off square, so the latch wouldn’t catch and the bottom rail ground against the concrete. We cut out the failed welds, rebuilt the hinge points on new pins, and trued the frame before rewelding. The gate now swings level and latches on the first push, and the driveway is clear again.
Gate Motor & Opener: LiftMaster Operator That Quit After a Power Surge
Before
After
The problem: a monsoon-season surge cooked the control board and left the homeowner dragging the gate open by hand. We diagnosed the LiftMaster unit, replaced the board, reset the travel limits, and confirmed the safety reverse was working. It’s running on command again, and we walked the homeowner through the manual release so a future outage doesn’t leave them stuck.
Gate Access Control: Keypad and Entry System Nobody Could Get Into


The problem: weather had gotten into the old keypad and the entry wiring was corroded, so codes went ignored and guests couldn’t get through. We replaced the keypad, cleaned up the low-voltage run, and reprogrammed each entry code. Every visitor code works again and only the codes the homeowner wants are active.
Gate Parts & Welding: Rusted Wrought-Iron Panel on a Desert-Facing Fence Line


The problem: years of harsh sun and seasonal dust had cracked the welds at the panel joints and rust was spreading across the ironwork. We ground out the bad joints, rewelded the pickets and frame, treated the rust, and refinished the panel. It’s solid to the push again and set to hold up through another round of Boulder City summers.
Gate Repair: Hinges That Shrieked Every Time the Gate Moved


The problem: the hinge pins had worn oblong and were grinding metal on metal, so every swing announced itself. We pulled the old hinges, fitted new pins, and adjusted the gate so it hangs true on its posts. The squeal is gone and the gate moves with a light push instead of a shove.
Gate Installation: Old Manual Gate Swapped for an Automated Entry


The problem: the homeowner was climbing out to open a heavy manual gate several times a day, and the old gate had started to bind anyway. We measured the opening, ordered the right gate and a FAAC operator, ran the power and safety edges, and set the keypad. The result is a gate that opens from the driver’s seat and closes with the safety sensors doing their job. Installation work like this gets scheduled around a free measure and a written price, so there are no surprises on the bill.
Want Results Like These?
If any of these before-and-after jobs look familiar, we can help. Call Ironworks Gate Co. Boulder City at (888) 276-7609 – a live person answers, day or night. We’ll quote your repair upfront, settle the price before a single bolt is turned, and back the work in writing with our 90-Day Done Right Promise. Estimates are free.
Written by the team at Ironworks Gate Co. Boulder City.
See the difference
Before
After
Before
After
Before
After