A Ironworks company - serving Boulder City, NV

Ghost Controls Keypad & Intercom Repair in Boulder City, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Ghost Controls Keypad & Intercom Repair: The Boulder City Owner’s Guide

Replacing a failed Ghost Controls keypad or intercom in Boulder City typically runs $180 to $360 installed, depending on whether we’re swapping a wireless keypad, a wired intercom station, or both, and most of that work is finished in a single visit. The keypads and intercom stations on Ghost Controls systems are the parts that live outdoors in full sun and desert grit, so they’re the first to go. You usually find out one of two ways: the code that opened your gate for years suddenly doesn’t, or the intercom goes silent on one end while the gate itself still runs fine. Either way, the gate motor isn’t the problem. The part at the post is.

Call (888) 276-7609

Which Ghost Controls Models This Applies To

Ghost Controls builds its reputation on the DIY-friendly dual-gate and single-swing operators, and the keypad and intercom accessories that pair with them. The wireless keypads are the most common add-on we see in Boulder City, and they’re model-specific in a way that trips people up: the pairing process and frequency differ across the operator generations, and a keypad bought for one generation won’t reliably talk to another. Before we quote anything, we read the label on the back of the operator head and match the keypad or intercom to that exact unit rather than guessing by looks.

Here’s the compatibility gotcha most owners miss. The older wireless keypads and the newer units can look nearly identical on the outside, but their internal pairing radio is not the same, and a mismatched replacement will either refuse to pair or drop the code every few weeks. If you’re ordering the part yourself, the model number on the operator label is the number that matters, not the model number on the keypad you’re replacing.

On the OEM-versus-aftermarket question, our honest position for Ghost Controls is this: the OEM accessory is worth it on the keypad and intercom because the pairing behavior is tied to the operator’s firmware, and a cheap universal pad often means a callback. We don’t keep parts on a truck or in a warehouse. We identify the correct part, source the right one, and bring it to your Boulder City property. Ironworks Gate Co. Boulder City is an independent service provider and is not affiliated with Ghost Controls. We also service LiftMaster, Mighty Mule, and DoorKing systems.

Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

These are the failures we see most on Ghost Controls accessories around Boulder City, and what’s actually going on underneath each one.

  • The code stops working after working for years. Usually a failed membrane keypad or a corrupted code memory in the pad itself, not the gate operator. The buttons feel fine but the internal contact has worn through.
  • Buttons need a hard press, or one number won’t register. The keypad’s membrane is degrading from UV and heat. This is the classic first stage before a full failure, and it’s the best time to replace it.
  • The intercom is silent on the house side only. A failed speaker or a broken wire at the station, often where the cable meets the post. The gate side works, so the operator is fine.
  • The intercom hums or crackles constantly. Moisture or grit has gotten into the station housing, or the wiring has a partial short. Desert dust and the occasional monsoon soak both find their way in.
  • Keypad lights are dead but the gate still opens from a remote. The keypad has lost power, either at its battery or its low-voltage feed. This one is worth checking before you assume the pad is gone.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Installed pricing for a Ghost Controls keypad or intercom replacement in Boulder City runs roughly $180 to $360. A straightforward wireless keypad swap sits at the low end; a wired intercom station that needs a new low-voltage run or a repair at the post pushes toward the top. The range is driven by the part itself, whether the wiring needs attention, and how the station is mounted.

What’s included is the diagnosis, the correct part sourced and matched to your operator, the install, the pairing or wiring, and a full test of every code and every intercom function before we leave. The price is quoted and agreed before any work starts, and it doesn’t change unless you approve a change. Every job is backed by our written 90-Day Done Right Promise: if it isn’t right, we come back and make it right. We also offer $50 off any repair over $250, a free second opinion on any written estimate, and a standing 5% senior and veteran discount.

DIY or Call Us?

There’s a small list of things you can safely check yourself. Confirm the keypad has power, look for obvious damage or corrosion at the housing, and make sure the batteries (if your unit uses them) are fresh. Beyond that, the work gets into low-voltage wiring, pairing sequences, and reading the operator’s behavior, and that’s where DIY usually goes sideways: a mis-paired pad that works for a week, or a wiring repair that leaves the intercom half-dead.

One honest note on safety: the keypad and intercom circuits are low-voltage, but they’re tied into a gate operator that moves real weight, and we never want you working inside an operator housing or reaching past a gate that could cycle. If your gate is moving on its own or the operator acts erratically, stop using it and call us. Our technicians have up to 13 years of experience on Ghost Controls and eight other brands, they’re background-checked and uniformed, and a live person answers the phone 24 hours a day. Call (888) 276-7609 and we’ll get the right part on the job.

FAQs

Need Gate Repair help nationwide? Licensed & insured · 1-hour response · free estimates
Call (888) 276-7609
Local Service Coverage

Request a Free Estimate in Boulder City

Tell us what you need - Ironworks Gate Co. Boulder City responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch