Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Access Control in Boulder City: What to Know First
We provide independent Ghost Controls gate access control service in Boulder City, from keypad entry and remotes to phone entry, card readers, video intercom, and smart access add-ons. Most access-control repairs are diagnosed and fixed in a single visit, and some diagnostics can be scheduled the same day depending on the week. You’ll get a written upfront price before any work begins, and if we can’t fix it, you don’t pay for a guess.
This page is for the homeowner whose Ghost Controls keypad has gone finicky, whose remote only works from ten feet away, or who wants a phone-entry or smart-access setup that actually survives Boulder City summers. If that’s you, call (888) 276-7609. A live person answers, day or night.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls makes solid DIY-friendly openers, and we service plenty of them across Boulder City. But their access-control components have failure patterns you won’t read about on the box. Here’s what our technicians actually see in the field.
- Keypad ghosting on the AXO and TDS series. The wireless keypad that pairs with Ghost Controls AXO (solar) and TDS (AC) operators will start “ghosting” – sending phantom open commands – after two or three Boulder City summers. The cause is usually a worn gasket letting in fine desert dust and UV-cracked membrane keys, not a bad board. We reseal or replace the keypad and re-pair it to the operator without touching the opener’s warranty-voiding internals.
- Remote range collapse on the H series. If your remote only works from the end of the driveway instead of the house, the culprit is almost always a failing receiver antenna or a receiver board that’s drifted in the heat. We test signal strength at the receiver, replace the antenna or receiver module, and re-program every remote you own so all of them work from the same distance again.
- Battery draw that kills the whole system. Solar Ghost Controls setups (AXO, TDS with solar) run off the battery. When the access-control add-ons – keypad, receiver, intercom – pull more than the panel can put back, the gate slows, then stops mid-cycle. We measure charge and draw with a meter, not a guess, and either upgrade the panel or move the accessories to a proper power source.
- Board water intrusion and corroded terminals. The control board on a Ghost Controls operator sits in a vented housing that should stay dry. In Boulder City, our monsoon weeks and cold snaps crack seals and drive dust in. Once a terminal corrodes, remotes drop out intermittently. We clean or replace the terminal block and re-seal the housing.
- Aftermarket remotes that “almost” work. Plenty of homeowners buy cheap third-party remotes on the internet, and about half of them don’t hold programming on Ghost Controls receivers. We program OEM-pattern remotes that will hold, or we recommend an upgrade path if the receiver itself is the weak link.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Access Control Process
- 1
Phone call, real person. You call (888) 276-7609, we answer, and we get your gate, model, and symptom on the record. No voicemail, no queue.
- 2
On-site diagnostic. We test the operator, the access-control accessory, the battery, the power source, and the programming. You get the finding in plain English before anything is ordered.
- 3
OEM vs. quality aftermarket. If a part needs replacing, we tell you what’s OEM for Ghost Controls, what’s a quality aftermarket equivalent, and what each does to your warranty. You choose.
- 4
Written price before we start. The number is settled and signed off before a single bolt is turned. No surprises on the bill.
- 5
Test everything with you. Every remote, keypad code, phone entry, and card you own gets tested at the gate before we call it done.
- 6
90-Day Done Right Promise. If anything we touched isn’t right, we come back and make it right. No paperwork. No arguing.
See the difference
Before
After
Before
After
Before
AfterWhat Ghost Controls Gate Access Control Costs in Boulder City
Every job gets a written estimate, free, so the number below is a range, not a bill. Here’s what Ghost Controls access-control work typically runs in Boulder City:
- Diagnostic visit: $75 – $125 (credited toward the repair if you hire us).
- Keypad replacement (Ghost Controls AXO or TDS pairing): $180 – $320 installed.
- Remote reprogramming (all remotes): $60 – $110.
- Receiver replacement or antenna repair: $140 – $280 installed.
- Phone entry or smart-access add-on (with panel check): $280 – $650, depending on whether the operator’s power supply needs upgrading.
- Card reader or video intercom integration: $550 – $1,200, quoted per gate.
What moves the price: whether the operator’s battery and solar panel can carry the add-on, whether the wiring run has to be re-pulled, and whether the gate’s hinges are dragging (that wears out operators and gate-access components faster than anything).
Call (888) 276-7609 for a free estimate and a written price. We’ll tell you what’s actually wrong before we charge you a cent.
Why Boulder City Homeowners Call Ironworks Gate Co. Boulder City for Ghost Controls Work
We’re an independent Ghost Controls service provider, and we’re upfront about that: we’re not authorized by Ghost Controls and we don’t pretend to be. What we are is trained and equipped on nine gate-automation brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so whatever’s on your driveway, we know it on sight.
A live person answers the phone 24 hours a day, 7 days a week. Our technicians have up to 13 years of experience and are background-checked and uniformed, and they work in your yard the way they’d work in their own mother’s. Every job is backed by the written 90-Day Done Right Promise.
We’re also running the standing offers: $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a permanent 5% senior and veteran discount. We stand behind it.
FAQs
Not if it’s done correctly. Replacing a keypad, re-pairing remotes, or resealing a housing is warranty-safe when OEM parts are used and the operator’s internals are left untouched. The warranty problem comes from drilling the operator housing, splicing into the board, or installing aftermarket accessories that exceed the operator’s rated output. We’ll tell you in writing which of those risks applies to your Ghost Controls unit before we do anything.
Most of what we need for access-control repairs – keypads, receivers, remotes, antennas, terminal blocks, batteries – we can source fast, and some jobs are fixed the same day. Special-order Ghost Controls parts like a specific control board or a discontinued model’s accessory usually take a few days. Your written estimate will say exactly what’s in stock and what’s coming.
Usually a repair. The receiver antenna or the receiver board is the weak link about four times out of five, not the remote. We test signal at the receiver first, replace the antenna or module, and re-program every remote on the property so they all reach the house again. Call (888) 276-7609 and we’ll give you a real number before we touch the gate.
Repair it if the operator and the gate hardware are sound and only the access control is failing. Replace it if the motor and gearbox have overlapping wear, or the control board is discontinued and no warranty-safe replacement exists. We tell you the honest answer either way. A 40-year-old gate can close like the day it was hung if the operator and the access control are right.
Yes. The catch is power. Ghost Controls operators were designed with a keypad and remote in mind, not a phone module, card reader, and intercom pulling together. We measure the draw against the panel’s output, and if the math doesn’t work, we’ll tell you what upgrade is needed rather than installing something that will fail in a year. Estimates are free – call (888) 276-7609.
Written by the team at Ironworks Gate Co. Boulder City, serving Boulder City and nearby areas.
Ironworks Gate Co. Boulder City
Call (888) 276-7609 for a free estimate. A live person answers, 24 hours a day, 7 days a week.