Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor & Opener in Boulder City: What to Know First
We repair, replace, and install Ghost Controls gate motors and openers across Boulder City, and most jobs are finished in a single visit. A straightforward repair like a dead control board or a stripped actuator usually runs $240 to $460, and a full Ghost Controls operator swap on a single swing gate typically lands between $850 and $1,650 installed. You’ll get a firm price in writing before we touch a bolt, and it doesn’t move once the work starts.
This page is for the homeowner whose Ghost Controls gate has stopped responding, whose remote works only when you’re standing in one exact spot, or whose opener has started beeping in the middle of the night. If that’s you, call (888) 276-7609. A live person answers, day or night.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls is a do-it-yourself-friendly brand, and that’s exactly why we see the failures we do in Boulder City. The gear is sound. The install and the sun are what wear it out. Here are the five patterns we run into most.
- Control board failure after a monsoon-season power surge, most often on the AXO and TSS series. Southern Nevada’s summer thunderstorms push voltage spikes down rural feed lines all over Boulder City, and the small board inside a Ghost Controls operator takes the hit before your house breaker does. Symptoms look like a dead unit: no beep, no LED, remote does nothing. We test the transformer and the board separately so you’re not paying for a whole new operator when a board is the actual fault.
- Faded and drifting photo-eye or edge sensor, common on the DIY-installed kits. These low-voltage sensors go out of alignment when the ground shifts, and the desert’s temperature swing between a cold January night and a July afternoon moves things more than most owners expect. The gate opens partway and reverses. We re-aim the eyes and check the edge-sensor wire run, because a chafed wire in a sun-baked conduit is a frequent false alarm.
- Battery backup that quietly stops holding a charge. Ghost Controls operators run on a sealed battery, and a battery that’s two summers old in this heat is a battery on borrowed time. The gate works fine on AC and dies the first time the power blinks. We load-test the battery instead of guessing, then replace it with the correct sealed unit.
- A stripped or slipping actuator arm on a swing gate that was never shimmed right. When a hinge sags, the arm fights it, and the gear inside the operator pays the price. We see this on the estate-style arms. The fix is two parts: replace the arm or actuator, and true up the hinge so the new part isn’t chewed up in a season. Skipping the hinge is why some gates eat motors.
- Intercom and keypad wiring that was never sealed against the dust. Ghost Controls integrates cleanly with entry keypads and intercoms, but the connections at the post need proper weatherproofing to last out here. Corroded terminals cause intermittent “ghost” opens at random hours. We clean and reseal the connections and verify every access point works the first time.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Motor & Opener Process
- 1
The call. A live person picks up, day or night. We ask what the gate is doing, what model you have if you know it, and where the operator sits. That saves time on the visit.
- 2
Diagnostics on site. We test power, control board, battery, sensors, and the mechanical arm as a system. A gate that won’t move can be a $60 battery or a $400 board, and guessing wastes your money.
- 3
The parts decision, in plain terms. Sometimes an OEM Ghost Controls part is the right call to keep things matched. Sometimes a quality aftermarket piece lasts longer, and sometimes it outright doesn’t. We tell you which and why, and you decide. Nothing gets ordered or installed until you approve the price.
- 4
The repair. Most jobs finish in one visit. If a part has to be ordered, we tell you exactly when we’ll be back and we’re there when we say.
- 5
The test. We cycle the gate multiple times, check the safety reversal, confirm every remote and keypad, and walk you through what we did.
- 6
The guarantee. Every job carries our 90-Day Done Right Promise in writing. If it’s not right, we come back and make it right.
What Ghost Controls Gate Motor & Opener Costs in Boulder City
These are real ranges for the Ghost Controls work we do around Boulder City. Your exact price depends on your gate, your model, and what the diagnostics turn up. You’ll get a written estimate before any work begins.
| Job | Typical Range |
|---|---|
| Diagnostic visit and written estimate | Free estimate |
| Battery backup replacement | $90 – $180 |
| Control board replacement | $240 – $460 |
| Photo-eye / edge sensor repair or replace | $150 – $320 |
| Actuator arm replacement (with hinge truing) | $320 – $600 |
| Full Ghost Controls single-swing operator install | $850 – $1,650 |
| Dual-gate operator install | $1,500 – $2,800 |
| Intercom or keypad integration | $200 – $450 |
What moves the price: whether the gate needs hinge work, whether the power run is already in place, and whether you want OEM or aftermarket parts. Tell us which, and we’ll sharpen the number on the phone. Call (888) 276-7609 for a free, no-pressure estimate.
See the difference
Before
After
Before
After
Before
AfterWhy Boulder City Homeowners Call Ironworks Gate Co. Boulder City for Ghost Controls Work
We’re an independent Ghost Controls service provider. We aren’t the manufacturer and aren’t authorized by them, but we’ve been welding gates and servicing their automation long enough to know where these units fail and how to fix them for good. Our technicians have up to 13 years of experience, and we’re trained on nine automation brands including LiftMaster, Mighty Mule, and DoorKing, so if your Ghost Controls system turns out to be the wrong fit for your gate, you’re not stuck with a brand. We can recommend and install what actually works.
A live person answers every call, 24 hours a day, seven days a week. Every job is backed by our written 90-Day Done Right Promise, our background-checked, uniformed technicians work in your home the way they’d work in their own mother’s, and the price is settled before a single bolt is turned. We’ve been serving local communities for 42 years and we plan to be here another forty.
FAQs
Does repairing my Ghost Controls opener void the manufacturer’s warranty? No, professional repair by an independent technician doesn’t void a Ghost Controls warranty, but using non-approved parts can affect a claim. We keep your warranty in mind, tell you when an OEM part is the safer choice, and do nothing that would put your coverage at risk.
Can you get Ghost Controls parts quickly in Boulder City? Yes, most common parts are available and many jobs finish the same day. Less common boards or actuators may need to be ordered, and when that happens we’ll tell you exactly when we’ll be back. Call (888) 276-7609 with your model number and we’ll tell you what’s in stock.
Is it worth repairing a Ghost Controls opener or should I replace it? Repair usually wins when the gate and arm are in good shape and the fault is a board, battery, or sensor. Replacement makes more sense when the operator is failing in several places at once or your gate has outgrown it. We’ll give you both numbers and an honest recommendation, with no pressure either way.
How fast can you get to my gate? For repairs and emergencies, we aim for same-day or next-day service across Boulder City. New installs are scheduled around a measure and order, so give us a call and we’ll set a firm date.
Do you handle the power run and the safety edges? Yes, a full Ghost Controls install includes the power run, safety edges, and every access point, tested and working before we leave. The price for all of it is agreed up front, so there’s nothing added to the bill afterward.
Get Your Ghost Controls Gate Working Again
If your Ghost Controls gate is stuck, beeping, or ignoring the remote, call (888) 276-7609 for a free estimate. We’ll diagnose it honestly, quote it plainly, and fix it right, backed in writing. New customers can take $50 off any repair over $250, and our senior and veteran discount is always available.
Written by the team at Ironworks Gate Co. Boulder City, serving Boulder City and nearby areas.